SAILAsterix
A FREEDOM 40 · A NEW CHAPTER

Teak restoration

Asterix · Woodwork · Refit in Oxnard

Bringing the teak
back to life.

Old varnish off, missing plugs replaced and three coats of Semco Clear. Amanda’s patient preparation transforms the teak around the cockpit.

Restoration completed8 November 2026
6 November 2026Amanda bringing the teak back to life around the mizzen.

Current position · 8 November 2026

Completed: old varnish removed, missing teak plugs replaced, small holes filled, surfaces cleaned and sanded, and three coats of Semco Clear applied.

The result: the exterior teak, principally around the cockpit, repaired and treated by Sunday lunchtime. Amanda did most of the preparation, with both of us working on the final finish.

Back to the wood.

The teak was one of those jobs that would change how the boat felt every time we stepped aboard. Around the cockpit we had old varnish to remove, weathered surfaces to clean and missing plugs to replace before applying a fresh treatment.

Amanda had already worked through the old varnish with a heat gun and scraper. During week three, while I was going up and down the masts, she kept steadily working on the woodwork.

6 November 2026 · Before treatmentThe weathered teak before the final cleaning and treatment.

Small holes.
A lot of careful preparation.

There were around nine or ten missing teak plugs to replace. Amanda dug out the old epoxy from the plug holes and prepared them for the replacements we collected from West Marine. A few holes needed drilling out, but the new plugs fitted nicely.

I attended to other small holes, mixing adhesive with teak dust I had saved to darken the repairs. We masked around the areas being filled, then worked through the tidying and sanding. Amanda sanded the plugs down flush so the wood was smooth and ready for treatment.

None of it was a large repair by itself. Together, those small jobs made the difference between simply putting a finish over the wood and getting the teak properly ready.

Amanda’s teak campaign.

Amanda used a two-part teak cleaner, working principally around the cockpit. By Friday the wood was looking bright again. Saturday was for the final preparation: finishing the repairs, sanding the plugs and making sure all the teak was clean for Sunday.

I helped with the filling and mixing, but Amanda had done the patient work of stripping and cleaning. As the masts reached their own milestones, the woodwork was coming together below.

8 November 2026Final preparation and masking around the companionway trim.

Three coats.
Finished before lunch.

Sunday was Semco day. We spent the morning applying the Clear product—labelled Cleartone on the tin—to the prepared teak. I had used it before, and it was satisfying to see the colour return as we worked around the boat.

Between us we applied three generous coats and used a whole quart across the teak. After all the stripping, plug repairs, filling and cleaning, the finishing itself brought the week’s work together.

8 November 2026The Semco Cleartone used for the finishing stage.
8 November 2026 · After treatmentThe repaired and treated teak, with the new plugs sanded flush.

We finished just before lunch. I tidied up while Amanda made a feta salad, and by Sunday afternoon she was on deck reading her book. The woodwork was one more substantial job crossed off the list.

From old varnish to treated teak.

Work Recorded result
Old varnish Removed by Amanda with a heat gun and scraper
Missing teak plugs Approximately nine or ten replaced; holes prepared and plugs sanded flush
Small holes and defects Filled with adhesive darkened using saved teak dust
Cleaning Two-part teak cleaner; final preparation completed on Saturday
Finish Semco Clear / Cleartone, three coats, one quart used
Completion Sunday 8 November 2026, before lunch

This records the restoration and treatment completed during this visit. We will add future maintenance and observations as the teak sees more use aboard Asterix.